Set Up the Vectorworks Template
- download
this vectorworks template.
- go to titleblock layer and add your logo to the title
block
- change measurement system and scale
- go to drawing layer
- under page go to units and change from millimeters to feet
& inches, ok.
- under page go to layer scale and convert to an appropriate
architectural scale. You may havetoguess and check later.
- under page go toset grid, snap grid 4" (you may wish to
change this later), reference grid 4', ok
- check to determine if the scale is appropriate for the
drawing. If not adjust scale as required. (you should use a
standard architectural scale)
Technological Design
Home